Graham Field 760000-INS-LAB-RevA08 Instrukcja Użytkownika Pobierz pdf (Strona 13)

760000-INS-LAB-RevA08 13

general maIntenanCe

1. Check main power cord for abrasion or excessive wear.

2. Check mattress cover for signs of wear or damage. En-

sure mattress cover and tubes are connected correctly.

3. Check airow from the air hose connector. The airow

should alternate between each connector every half-

cycle time if it’s in alternating mode.

4. Check the air hoses for any kink or break. For replace-

ment, please contact your GF equipment provider.

Fuse replacement

tool needed: small screwdriver

1. If you suspect a blown fuse, discon-

nect the plug from the wall outlet

immediately.

2. Use a small screwdriver to remove

the cover of the fuse holder (fuse locations are shown

in picture at right).

3. Insert a new fuse of the correct rating (T1A/250V, VDE

approved).

4. Replace the fuse holder cover. Ensure that fuse holder

cover is securely installed.

Air lter replacement

tool needed: small screwdriver

1. Use a small screwdriver to remove

the air lter plate located at rear

of pump (lter location shown in

picture at right).

2. Remove the lter. The lter is reusable, if not torn, and

can be washed gently with a mild detergent and water.

Dry the lter before use.

3. Replace the lter and cover. Ensure that lter cover is

securely installed. Replace the air lter regularly if it is

gray, torn, or the environment is dirty.

fuse

filter

1 2 ... 8 9 10 11 12 13 14 15 16

Brak uwag

Graham Field 760000-INS-LAB-RevA08 Instrukcja Użytkownika Strona 13